LJTick-InBuff (LJTIB) 는 LabJack 제품에 pH sensors 를 직접 측정하고 다른 종류의 약한 신호를 측정할 수 있도록 하는 제품입니다. LabJack DAQ 제품 (U3, U6, UE9, and T7) 는 10 ~ 100pA 의 전류가 필요합니다. 이 악세사리는 사용자가 10MΩ 이상의 소스 임피던스를 가진 신호를 측정할 수 있도록 도울 수 있습니다. LJTick-InBuff 는 텍사스 인스트루먼트 사의 OPA2140 를 추가 제품의 아날로그 입력과 센서 사이에 고정밀, 저잡음 OP 증폭을 제공합니다.
Common Applications
Screw Terminal DescriptionsVS: This is the same 5 volt output as the VS terminals on the LabJack itself. This is an output terminal, not an input. It can be used to provide 5 volt (nominal) power as needed. GND: Same as LabJack ground (GND). INA/INB: These input lines go through the Op Amps to have their signals amplified before being sent to a LabJack device.
LJTick-InBuff Hardware Block DiagramFigure 3: LJTick-InBuff Schematic
LJTick-InBuff SchematicFigure 4: LJTick-InBuff Schematic
Usage with the T4 or U3-HVThe T4 and U3-HV have a mix of high voltage analog inputs (±10 volt range) and low voltage analog inputs (±2.5/2.4 volt range). Most input ticks are best used with the low voltage analog inputs, but the LJTick-InBuff is unique in that it has a ±10 volt output range and thus either type of analog input might be best depending on the range of the input signal.
Specifications:
For more specifications about the Op Amp used in the LJTick-InBuff refer to the Texas Instruments OPA2140 datasheet. |